this is the code for the render ad
Community› Local Wedding Boards› Minnesota-Minneapolis and St. Paul
Minnesota-Minneapolis and St. Paul
New Discussion

Anyone use pillar candles in glass cylinders??

jessy_grossjessy_gross
10 Comments
in Minnesota-Minneapolis and St. Paul
I ordered glass cylinders (7.5" tall from Dollar Tree), and I was planning to put pillar candles in them, but the bottom inside the cylinder isn't quite flat, so the candles wouldn't sit flat.    I was wondering if anyone else has used these cylinders with candles-- do the candles still burn ok, or will they look messy and have wax dripping off one side if they're not sitting straight?  TIA!
241 Invited image 117 Attending image 104 Declined image 20 Don't know what RSVP meansimage
Report Reply to Post

Re: Anyone use pillar candles in glass cylinders??

  • MrsBassPlayaMrsBassPlaya member
    500 Comments Third Anniversary
    edited December 2011
    I haven't used the cylinders, but what about maybe putting a little sand in the bottom of them to help even everything out?

    So In Love

    image
    Josh and Renata's Wedding

    Planning Bio
    Report Reply
  • tpender13tpender13 member
    2500 Comments
    edited December 2011
    In Response to <a href="http://forums.theknot.com/Sites/theknot/Pages/Main.aspx/local-wedding-boards_minnesota-minneapolis-st-paul_anyone-use-pillar-candles-glass-cylinders?plckFindPostKey=Cat:Local%20Wedding%20BoardsForum:81Discussion:8587643d-84b8-43bf-8dc0-440fbead631bPost:160aad04-4fc2-49df-b2e6-376bd939900b">Re: Anyone use pillar candles in glass cylinders??</a>:
    [QUOTE]I haven't used the cylinders, but what about maybe putting a little sand in the bottom of them to help even everything out?
    Posted by MrsBassPlaya[/QUOTE]

    This is what I was going to say. You could find pretty colored sand from a craft store, or somewhere on the interwebs.
    image
    Report Reply
  • wittyschaffywittyschaffy member
    Knottie Warrior 1000 Comments Combo Breaker
    edited December 2011
    You could also try the trick I use on candlesticks when the base is too big for the candle base - drip a little wax from another candle into the bottom of the cylinder and then set your permanent candle on top.  When the wax sets, your candle will be "stuck" in the right spot.  You will have to be careful moving them though because it could pop free if it got moved too much.  If you're just using a little dab, nobody will see it (and if they do, they're looking way to dang close!).
    Report Reply
  • shan87shan87
    2500 Comments Combo Breaker
    edited December 2011
    We used a glass vase for our memorial candle (it was on the altar and they wanted us have it covered JIC)... we had the same problem but filled the bottom with extra gems from the centerpiece. If you are doing them for every table I think sand is a cheaper option.
    Report Reply
  • MilitaryBride2BeMilitaryBride2Be
    500 Comments
    edited December 2011
    My centerpieces were exactly what you discribed. We did have quite a few that didn't sit completely flat, but none of mine were extremely noticable and I just left it. I had forgotten about them until now lol. I didn't have any problems with them burning during the reception.
    image
    Planning Bio Updated 4/1
    Married Bio Updated 5/14: Now with Vendor Reviews!
    Report Reply
This discussion has been closed.
Choose Another Board
Search Boards